Control 4 Door Station - Interior Instrukcja Konfiguracji Pobierz pdf (Strona 4)

Power and Network Installations

Choose one of these six (6) options to connect the

Door Station’s wiring:

• Ethernet with PoE (preferred)

• Ethernet with AC

• Ethernet with DC

• WiFi with AC

• WiFi with DC

• WiFi with PoE

Option 1 (Preferred): Ethernet Connection with a

PoE Injector or a Third-Party Injector or Switch

This option sets up Ethernet with PoE.

PoE injects electrical current into the Ethernet cable

using a PoE Injector (model #AC-POE1-B) or a third-

party PoE solution to provide the Door Station with

power and a network connection.

To install the Door Station with a PoE and Ethernet

connection using a PoE Injector:

1 Plug the Ethernet cable into the Door Station

(see Figure 3).

Figure 3. Ethernet with PoE Injector

Option 2: Ethernet Connection with AC Power

This option sets up Ethernet and AC power.

To install the Door Station with Ethernet and AC

power:

1 Plug the Ethernet cable into the Door Station

(see Figure 4).

2 Connect the neutral (N) (-) and hot (L) (+) wires

to the AC power source for the Door Station

according to the national and local electrical

codes.

TIP: The hot or ‘L’ (+) wire’s connector is

closest to the bottom of the Door Station’s

plate.

3 Your installation may require alternative wires and

the use of a terminal block. Strip the power wires

to 1/4” on the end if necessary.

Figure 4. Ethernet with AC Power

Option 3: Ethernet Connection with DC Power

This option sets up Ethernet and DC power.

Ethernet Connection

Ethernet Cable

AC Connections

(Hot and Load)

1 2 3 4 5 6 7 8 9 10 11

Komentarze do niniejszej Instrukcji

Brak uwag

Control 4 Door Station - Interior Instrukcja Konfiguracji Strona 4

Komentarze do niniejszej Instrukcji